Rohde & Schwarz SMW-K144 - Dummy Resource Elements Commands

Remote-Control Commands
R&S
®
SMW-K144
179User Manual 1178.8013.02 ─ 06
Parameters:
<SSPbchCellBarre> BARR | NBAR
*RST: BARR
Example: See Example "Configuring the SS/PBCH" on page 149.
Manual operation: See "Cell Barred" on page 48
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:SSPBch<st0>:MIB:IFRResel
<SSPbchInFreqSel>
Sets the value of the system information parameter intraFreqReselection.
Parameters:
<SSPbchInFreqSel> ALWD | NALW
*RST: ALWD
Example: See Example "Configuring the SS/PBCH" on page 149.
Manual operation: See "Intra Freq Reselection" on page 48
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:SSPBch<st0>:MIB:SPARe:STATe
<PbchSpareState>
Sets the system information bit spare, as defined in TS 38.331.
Parameters:
<PbchSpareState> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Configuring the SS/PBCH" on page 149.
Manual operation: See "Spare" on page 48
8.6 Dummy Resource Elements Commands
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:DUMRes:STATe......................................... 179
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:DUMRes:POWer........................................180
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:DUMRes:SCSPacing..................................180
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:DUMRes:MODulation................................. 180
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:DUMRes:SLTFmt....................................... 181
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:DUMRes:TPSTate...................................... 181
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:DUMRes:DATA.......................................... 181
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:DUMRes:DLISt.......................................... 181
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:DUMRes:PATTern...................................... 182
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:DUMRes:STATe <DummyResState>
Enables filling in unallocated resource elements (RE) with dummy data.
Dummy Resource Elements Commands