Rohde & Schwarz SMW-K144 - Page 48

5G New Radio Configuration and Settings
R&S
®
SMW-K144
48User Manual 1178.8013.02 ─ 06
Remote command:
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:SSPBch<st0>:MIB:SCSC
on page 177
DMRS Type A Position ← MIB Content
Indicates the first symbol that the DMRS uses, as set with the parameter "Node > Car-
riers" > DMRS Type A Position.
SSPBCH Subcarrier Offset ← MIB Content
Indicates the SS/PBCH subcarrier offset, calculated automatically depending on the
selected "Node > SS/PBCH" > SC Offset/SC Offset (15 kHz SCS)/SC Offset (60 kHz
SCS).
Remote command:
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:SSPBch<st0>:MIB:SCOFfset?
on page 178
CORESET Zero ← MIB Content
Sets the common control resource set (CORESET) of the initial downlink BWP
controlResourceSetZero carried by the PDCCH-ConfigSIB1 information ele-
ment, as defined in TS 38.331.
Remote command:
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:SSPBch<st0>:MIB:CSZero
on page 178
Search Space Zero ← MIB Content
Sets the common search space of the initial downlink BWP searchSpaceZero car-
ried by the PDCCH-ConfigSIB1 information element, as defined in TS 38.331.
Remote command:
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:SSPBch<st0>:MIB:SSZero
on page 178
Cell Barred ← MIB Content
Cell barring (cellBarred) is system information that indicates if UEs can camp on the
particular cell notBarred or not barred.
Remote command:
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:SSPBch<st0>:MIB:CBARred
on page 178
Intra Freq Reselection ← MIB Content
Sets the value of the system information parameter intraFreqReselection.
Set "Intra Freq Reselection > Allowed" to allow UEs to perform cell reselection to intra-
frequency cells.
Remote command:
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:SSPBch<st0>:MIB:IFRResel
on page 179
Spare ← MIB Content
Sets the system information bit spare, as defined in TS 38.331.
Node Settings