Rohde & Schwarz SMW-K144 - Page 177

Remote-Control Commands
R&S
®
SMW-K144
177User Manual 1178.8013.02 ─ 06
Parameters:
<DataList> string
Filename incl. file extension or complete file path
Example: See Example "Configuring the SS/PBCH" on page 149.
Manual operation: See "Data Source" on page 46
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:SSPBch<st0>:CCODing:PATTern
<Pattern>, <BitCount>
Sets a bit pattern as a data source.
Parameters:
<Pattern> numeric
*RST: #H0
<BitCount> integer
Range: 1 to 64
*RST: 1
Example: See Example "Configuring the SS/PBCH" on page 149.
Manual operation: See "Data Source" on page 46
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:SSPBch<st0>:MIB:STATe
<SSPbchMIBState>
Defines how the MIB is defined.
Parameters:
<SSPbchMIBState> 0 | 1 | OFF | ON
1|ON
This is a faster way to define the MIB.
You can define if channel coding is used or not and select an
arbitrary data source; further settings are not required.
0|OFF
Allows you to configure the MIB content according to TS 38.331.
*RST: 1
Example: See Example "Configuring the SS/PBCH" on page 149.
Manual operation: See "Dummy Content for MIB" on page 45
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:SSPBch<st0>:MIB:SCSC
<SSPbchSCSCommon>
Selects the common SCS (subcarrier spacing).
Parameters:
<SSPbchSCSCommon>N15_60 | N30_120
*RST: N15_60
SS/PBCH Commands