Rohde & Schwarz SMW-K144 - Page 45

5G New Radio Configuration and Settings
R&S
®
SMW-K144
45User Manual 1178.8013.02 ─ 06
3. Select "Node > SS/PBCH > SS/PBCH Pattern Table > Pattern# > PBCH > Config".
This dialog comprises the settings of the broadcast channel (PBCH) channel cod-
ing settings.
Settings:
Dummy Content for MIB................................................................................................45
Dummy Content............................................................................................................ 46
└ Channel Coding.............................................................................................. 46
└ Transport Block Size.......................................................................................46
└ Data Source....................................................................................................46
MIB Content.................................................................................................................. 47
└ SCS Common.................................................................................................47
└ DMRS Type A Position................................................................................... 48
└ SSPBCH Subcarrier Offset.............................................................................48
└ CORESET Zero.............................................................................................. 48
└ Search Space Zero.........................................................................................48
└ Cell Barred......................................................................................................48
└ Intra Freq Reselection.....................................................................................48
└ Spare.............................................................................................................. 48
Dummy Content for MIB
Defines how the MIB is defined:
"On"
This is a faster way to define the MIB.
You can define if channel coding is used or not and select an arbitrary
data source; further settings are not required.
See "Dummy Content" on page 46.
"Off"
Disable this parameter if you wish to configure the MIB content
according to TS 38.331.
See "MIB Content" on page 47.
Node Settings