5G New Radio Configuration and Settings
R&S
®
SMW-K144
35User Manual 1178.8013.02 ─ 06
Remote command:
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:TXBW:S30K:OFFSet on page 171
etc.
k0u ← TxBW table
Indicates the value of the parameter k
0
μ
, that defines the number of subcarriers the
transmission bandwidth is shifted related to the carrier center.
The value is calculated automatically, based on the selected SCS and "Channel Band-
width".
According to the specification, k
0
μ
= {-6, 0, 6}. If value different than these allowed val-
ues is displayed, a conflict is indicated. Use the Resolve Conflicts function to recalcu-
late the values.
The value k
0
μ
= "-" indicates that the SCS is not used (Use > "Off").
See Chapter 3.6, "Transmission Bandwidths TxBWs", on page 15.
Remote command:
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:TXBW:S30K:KOMU? on page 171
etc.
5.2.4 SS/PBCH Settings
Access:
1. Select "5G New Radio > General > Link Direction > Downlink".
2. Select "5G New Radio > General > Node > SS/PBCH".
This dialog comprises the settings of the broadcast channel (PBCH) and the syn-
chronization signals (SS). The SS and the PBCH are cell-specific and are always
transmitted in a block. For more information, see Chapter 3.7, "Synchronization
Signals and SS/PBCH Block", on page 17.
Settings:
Cell................................................................................................................................36
Antenna Port................................................................................................................. 36
Number of SS/PBCH Patterns...................................................................................... 36
Node Settings
To Next Page
Loading...