Rohde & Schwarz SMW-K144 - Trigger Commands

Remote-Control Commands
R&S
®
SMW-K144
261User Manual 1178.8013.02 ─ 06
Example: See [:SOURce<hw>]:BB:NR5G:OUTPut:POWer:MODE
on page 260.
Manual operation: See "Reference System Bandwidth" on page 143
8.17 Trigger Commands
[:SOURce<hw>]:BB:NR5G[:TRIGger]:SEQuence..............................................................261
[:SOURce<hw>]:BB:NR5G:TRIGger:SOURce...................................................................261
[:SOURce<hw>]:BB:NR5G:TRIGger:EXTernal:SYNChronize:OUTPut................................. 262
[:SOURce<hw>]:BB:NR5G:TRIGger:DELay:UNIT............................................................. 262
[:SOURce<hw>]:BB:NR5G:TRIGger[:EXTernal]:DELay......................................................262
[:SOURce<hw>]:BB:NR5G:TRIGger[:EXTernal]:INHibit......................................................263
[:SOURce<hw>]:BB:NR5G:TRIGger:EXTernal:RDELay?....................................................263
[:SOURce<hw>]:BB:NR5G:TRIGger:EXTernal:TDELay......................................................263
[:SOURce<hw>]:BB:NR5G:TRIGger:OBASeband:DELay...................................................264
[:SOURce<hw>]:BB:NR5G:TRIGger:OBASeband:INHibit...................................................264
[:SOURce<hw>]:BB:NR5G:TRIGger:OBASeband:RDELay?...............................................264
[:SOURce<hw>]:BB:NR5G:TRIGger:OBASeband:TDELay.................................................265
[:SOURce<hw>]:BB:NR5G:TRIGger:ARM:EXECute.......................................................... 265
[:SOURce<hw>]:BB:NR5G:TRIGger:EXECute.................................................................. 265
[:SOURce<hw>]:BB:NR5G:TRIGger:RMODe?..................................................................265
[:SOURce<hw>]:BB:NR5G:TRIGger:SLENgth...................................................................266
[:SOURce<hw>]:BB:NR5G:TRIGger:SLUNit..................................................................... 266
[:SOURce<hw>]:BB:NR5G[:TRIGger]:SEQuence <TrigMode>
Sets the trigger mode.
Parameters:
<TrigMode> AUTO | RETRigger | AAUTo | ARETrigger | SINGle
*RST: AUTO
Example: See Example "Configure and enable triggering" on page 162.
Manual operation: See "Trigger Mode" on page 125
[:SOURce<hw>]:BB:NR5G:TRIGger:SOURce <TrigSource>
Selects the trigger signal source and determines the way the triggering is executed.
Provided are:
●
Internal triggering by a command (INTernal)
●
External trigger signal via one of the local or global connectors
– EGT1|EGT2: External global trigger
– EGC1|EGC2: External global clock
– ELTRigger: External local trigger
– ELCLock: External local clock
Trigger Commands