Rohde & Schwarz SMW-K144 - Page 262

Remote-Control Commands
R&S
®
SMW-K144
262User Manual 1178.8013.02 ─ 06
●
Internal triggering by a signal from the other basebands (INTA|INTB)
●
In master-slave mode, the external baseband synchronization signal (BBSY)
●
OBASeband|BEXTernal|EXTernal: Setting only
Provided only for backward compatibility with other Rohde & Schwarz signal gener-
ators.
The R&S SMW accepts these values and maps them automatically as follows:
EXTernal = EGT1, BEXTernal = EGT2, OBASeband = INTA or INTB
(depending on the current baseband)
Parameters:
<TrigSource> INTB|INTernal|OBASeband|EGT1|EGT2|EGC1|EGC2|ELTRig-
ger|INTA|ELCLock|BEXTernal|EXTernal | BBSY
*RST: INTernal
Example: See Example "Configure and enable triggering" on page 162.
Options: ELTRigger|ELCLock require R&S SMW-B10
BBSY require R&S SMW-B9
Manual operation: See "Trigger Source" on page 127
[:SOURce<hw>]:BB:NR5G:TRIGger:EXTernal:SYNChronize:OUTPut
<TrigSyncOutpSta>
Enables signal output synchronous to the trigger event.
Parameters:
<TrigSyncOutpSta> 0 | 1 | OFF | ON
*RST: 1
Example: See Example "Configure and enable triggering" on page 162.
Manual operation: See "Sync. Output to External Trigger/Sync. Output to Trigger"
on page 127
[:SOURce<hw>]:BB:NR5G:TRIGger:DELay:UNIT <TrigDelUnit>
Sets the units the trigger delay is expressed in.
Parameters:
<TrigDelUnit> SAMPle | TIME
*RST: SAMPle
Example: See Example "Specifying delay and inhibit values in time units"
on page 163.
Manual operation: See "(External) Delay Unit" on page 128
[:SOURce<hw>]:BB:NR5G:TRIGger[:EXTernal]:DELay <TrigExtDelay>
Sets the trigger delay.
Trigger Commands