Rohde & Schwarz SMW-K144 - Properties Settings

5G New Radio Configuration and Settings
R&S
®
SMW-K144
50User Manual 1178.8013.02 ─ 06
5.3.2 Properties Settings
Access:
► Select "5G New Radio > General > Users/BWPs > Properties".
This dialog comprises the user-specific general settings.
Settings:
User...............................................................................................................................50
UE ID (RNTI).................................................................................................................50
DSCH/USCH Channel Coding......................................................................................50
(P)DSCH/(P)USCH Data Source.................................................................................. 51
User
Selects the user to be configured.
Remote command:
via suffix at USER<ch>
UE ID (RNTI)
Sets the RNTI of the user.
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:UEID on page 184
DSCH/USCH Channel Coding
Depending on the selected "Link Direction" direction, enables DSCH/USCH channel
coding.
Configure the corresponding settings in "Scheduling > User x BWP x > Content >
PDSCH/PUSCH > Settings > Config" > Channel Coding Settings dialog.
If PDSCH Scheduling = "Auto/DCI", the "DSCH Channel Coding" = "On".
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:DSCH:CCODing:STATe?
on page 184
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:USCH:CCODing:STATe
on page 184
Users/BWPs Settings