Rohde & Schwarz SMW-K144 - Page 184

Remote-Control Commands
R&S
®
SMW-K144
184User Manual 1178.8013.02 ─ 06
[:SOURce<hw>]:BB:NR5G:UBWP:NUSer <NumUsers>
Sets the number of simulated users.
Parameters:
<NumUsers> integer
Range: 1 to 10
*RST: 1
Example: See Example "Configuring the users and the BWPs"
on page 151.
Manual operation: See "Number of Users" on page 49
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:UEID <UserId>
Sets the RNTI of the user.
Parameters:
<UserId> integer
Range: 0 to 65535
*RST: 0
Example: See Example "Configuring the users and the BWPs"
on page 151.
Manual operation: See "UE ID (RNTI)" on page 50
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:USCH:CCODing:STATe
<UschChaCod>
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:DSCH:CCODing:STATe?
<DschChaCod>
Enables DSCH/USCH channel coding.
Parameters:
<DschChaCod> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Configuring the users and the BWPs"
on page 151.
Usage: Query only
Manual operation: See "DSCH/USCH Channel Coding" on page 50
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:USCH:DATA <UschDataSource>
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:DSCH:DATA <DschDataSource>
Sets the DSCH/USCH data source.
User Commands