Rohde & Schwarz SMW-K144 - Page 265

Remote-Control Commands
R&S
®
SMW-K144
265User Manual 1178.8013.02 ─ 06
[:SOURce<hw>]:BB:NR5G:TRIGger:OBASeband:TDELay <IntOthDelaySec>
Specifies the trigger delay for triggering by the signal from the other path.
Parameters:
<IntOthDelaySec> float
Range: 0 to 688
Increment: 250E-12
*RST: 0
Default unit: s
Example: See Example "Specifying delay and inhibit values in time units"
on page 163.
Manual operation: See "(Specified) External Delay/(Specified) Trigger Delay"
on page 129
[:SOURce<hw>]:BB:NR5G:TRIGger:ARM:EXECute
Stops signal generation; a subsequent trigger event restarts signal generation.
Example:
SOURce1:BB:NR5G:TRIGger:SOURce INT
SOURce1:BB:NR5G:TRIGger:SEQuence ARETrigger
SOURce1:BB:NR5G:TRIGger:EXEcute
// executes a trigger, signal generation starts
SOURce1:BB:NR5G:TRIGger:ARM:EXECute
// signal generation stops
SOURce1:BB:NR5G:TRIGger:EXEcute
// executes a trigger, signal generation starts again
Usage: Event
Manual operation: See "Arm" on page 126
[:SOURce<hw>]:BB:NR5G:TRIGger:EXECute
Executes a trigger.
Example:
See Example "Configure and enable triggering" on page 162.
Usage: Event
Manual operation: See "Execute Trigger" on page 126
[:SOURce<hw>]:BB:NR5G:TRIGger:RMODe?
Queries the signal generation status.
Return values:
<TrigRunMode> STOP | RUN
*RST: STOP
Example:
SOURce1:BB:NR5G:TRIGger:RMODe?
Trigger Commands