Rohde & Schwarz SMW-K144 - Page 264

Remote-Control Commands
R&S
®
SMW-K144
264User Manual 1178.8013.02 ─ 06
Example: See Example "Specifying delay and inhibit values in time units"
on page 163.
Manual operation: See "(Specified) External Delay/(Specified) Trigger Delay"
on page 129
[:SOURce<hw>]:BB:NR5G:TRIGger:OBASeband:DELay <TrigIntOthDelay>
Sets the trigger delay for triggering by the trigger signal from the other path.
Parameters:
<TrigIntOthDelay> float
Range: 0 to 2147483647
Increment: 0.01
*RST: 0
Example: See Example "Configure and enable triggering" on page 162.
Manual operation: See "(Specified) External Delay/(Specified) Trigger Delay"
on page 129
[:SOURce<hw>]:BB:NR5G:TRIGger:OBASeband:INHibit <IntOthInhibit>
For triggering via the other path, specifies the duration by which a restart is inhibited.
Parameters:
<IntOthInhibit> integer
Range: 0 to 67108863
*RST: 0
Example: See Example "Configure and enable triggering" on page 162.
Manual operation: See "External / Trigger Inhibit" on page 128
[:SOURce<hw>]:BB:NR5G:TRIGger:OBASeband:RDELay?
Queries the time a trigger event form the other path is delayed.
Return values:
<IntOthRDelaySec> float
Range: 0 to 688
Increment: 250E-12
*RST: 0
Example: See Example "Specifying delay and inhibit values in time units"
on page 163.
Usage: Query only
Manual operation: See "Actual Trigger Delay/Actual External Delay" on page 129
Trigger Commands