Rohde & Schwarz SMW-K144 - Page 40

5G New Radio Configuration and Settings
R&S
®
SMW-K144
40User Manual 1178.8013.02 ─ 06
PBCH Config ← SS/PBCH patterns table
Accesses the dialog with PBCH settings, see Chapter 5.2.7, "PBCH Settings",
on page 44.
PSS/SSS Power ← SS/PBCH patterns table
Sets the relative power of the allocations of the primary and the secondary synchroni-
zation signals (PSS and SSS).
The value is set relative to the power of the other resource elements.
Remote command:
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:SSPBch<st0>:PSSPow
on page 176
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:SSPBch<st0>:SSSPow
on page 176
PBCH Power ← SS/PBCH patterns table
Sets the relative power of the PBCH allocation.
The value is set relative to the power of the other resource elements.
Remote command:
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:SSPBch<st0>:POWer on page 176
State ← SS/PBCH patterns table
Disables the transmission of SS/PBCH.
Remote command:
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:SSPBch<st0>:STATe on page 173
Node Settings