Rohde & Schwarz SMW-K144 - Page 252

Remote-Control Commands
R&S
®
SMW-K144
252User Manual 1178.8013.02 ─ 06
Parameters:
<OCCindex> integer
Range: 0 to 6
*RST: 0
Example: See Example "Configuring the PUCCH settings" on page 161.
Manual operation: See "OCC Index" on page 120
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:PUCCh:FS:OCCLength <PucchOCCLength>
For PUCCH format F4, sets the OCC length.
Parameters:
<PucchOCCLength> L2 | L4
*RST: L2
Example: See Example "Configuring the PUCCH settings" on page 161.
Manual operation: See "OCC Length" on page 120
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:PUCCh:PL:SRCount <SrCount>
Sets the number of positive scheduling requests (SR).
Parameters:
<SrCount> integer
Range: 0 to 10
*RST: 0
Example: See Example "Configuring the PUCCH settings" on page 161.
Manual operation: See "Positive SR Count" on page 120
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:PUCCh:PL:UCI:BITS <PucchUciBits>
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:PUCCh:PL:ACK:BITS <ACKBitSize>
Sets the number of ACK/UCI bits.
Parameters:
<ACKBitSize> float
Range: 0 to 128
Increment: 1
*RST: 0
Example: See Example "Configuring the PUCCH settings" on page 161.
Manual operation: See "Number of ACK Bits" on page 121
PUCCH Commands