Rohde & Schwarz SMW-K144 - Page 247

Remote-Control Commands
R&S
®
SMW-K144
247User Manual 1178.8013.02 ─ 06
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:CS:DCI<s2us0>:ZCRTrigg <ZpCsiRsTrigg>
Sets the DCI field ZP CSI-RS trigger.
Parameters:
<ZpCsiRsTrigg> integer
Range: 0 to 3
*RST: 0
Manual operation: See "DCI Format 1_1" on page 113
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:CS:DCI<s2us0>:TCI <TCI>
Sets the DCI field transmission configuration indication.
Parameters:
<TCI> integer
Range: 0 to 7
*RST: 0
Manual operation: See "DCI Format 1_1" on page 113
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:CS:DCI<s2us0>:CBGTi <CBGTI>
Sets the DCI field CBG transmission information (CBGTI).
Parameters:
<CBGTI> integer
Range: 0 to 255
*RST: 0
Manual operation: See "DCI Format 1_1" on page 113
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:CS:DCI<s2us0>:CBGFi <CBGFI>
Sets the DCI field CBG flushing out information (CBGFI).
Parameters:
<CBGFI> 0 | 1 | OFF | ON
*RST: 0
Manual operation: See "DCI Format 1_1" on page 113
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:CS:DCI<s2us0>:STATe <ChanCodingState>
Enables channel coding for the DCI type custom.
CORESET Commands