Rohde & Schwarz SMW-K144 - Page 234

Remote-Control Commands
R&S
®
SMW-K144
234User Manual 1178.8013.02 ─ 06
Parameters:
<CSDmrsScramStat> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Configuring the CORESET settings"
on page 157.
Manual operation: See "Use DMRS Scrambling ID" on page 102
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:CS:DMRS:SCRam:ID <DmrsScramId>
Sets the DMRS scrambling ID.
Parameters:
<DmrsScramId> integer
Range: 0 to 65535
*RST: 0
Example: See Example "Configuring the CORESET settings"
on page 157.
Manual operation: See "ID" on page 102
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:CS:IL:STATe <CSIntlState>
If enabled, the CCE-to-REG mapping is interleaved.
Parameters:
<CSIntlState> 0 | 1 | OFF | ON
Example: See Example "Configuring the CORESET settings"
on page 157.
Manual operation: See "Interleaving State" on page 102
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:CS:IL:BUNSize <BundleSize>
Sets the bundle size L.
Parameters:
<BundleSize> BS2 | BS6 | BS3
*RST: BS6
Example: See Example "Configuring the CORESET settings"
on page 157.
Manual operation: See "Bundle Size" on page 103
CORESET Commands