Rohde & Schwarz SMW-K144 - Page 267

Remote-Control Commands
R&S
®
SMW-K144
267User Manual 1178.8013.02 ─ 06
Manual operation: See "Marker Mode" on page 130
[:SOURce<hw>]:BB:NR5G:TRIGger:OUTPut<ch>:DELay <MarkDelay>
Defines the delay between the signal on the marker outputs and the start of the sig-
nals.
Parameters:
<MarkDelay> float
Range: 0 to 16777215
Increment: 1E-3
*RST: 0
Example: See Example "Configure and enable standard marker signals"
on page 163.
Manual operation: See "Marker x Delay" on page 132
[:SOURce<hw>]:BB:NR5G:TRIGger:OUTPut<ch>:PERiod <MarkUsrPer>
Sets the period of the user-defined period marker.
Parameters:
<MarkUsrPer> integer
Range: 1 to 4294967295
*RST: 2
Example: See Example "Configure and enable standard marker signals"
on page 163.
Manual operation: See "Marker Mode" on page 130
[:SOURce<hw>]:BB:NR5G:TRIGger:OUTPut<ch>:ROFFset <MarkRiseOffs>
[:SOURce<hw>]:BB:NR5G:TRIGger:OUTPut<ch>:FOFFset <MarkFallOffs>
Sets the rise/fall offset.
Parameters:
<MarkFallOffs> integer
Range: -640000 to 640000
*RST: 0
Example: See Example "Configure and enable standard marker signals"
on page 163.
Manual operation: See "Rise/Fall Offset" on page 131
[:SOURce<hw>]:BB:NR5G:TRIGger:OUTPut<ch>:ONTime <MarkTimeOn>
[:SOURce<hw>]:BB:NR5G:TRIGger:OUTPut<ch>:OFFTime <MarkTimeOff>
Sets the number of samples during which the marker output is on or off.
Marker Commands