Rohde & Schwarz SMW-K144 - Page 107

5G New Radio Configuration and Settings
R&S
®
SMW-K144
107User Manual 1178.8013.02 ─ 06
Remote command:
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:CS:DCI<s2us0>:RNTI on page 237
DCI Format ← DCI Table
Sets the DCI format.
The downlink control information (DCI) is a message used to control the physical layer
resource allocations. It carries scheduling information and power control commands.
Available are the DCI formats "0_0", "1_0", "0_1", "1_1" and the "Custom" format with
user-definable content.
To configure the parameters per DCI format, select "Content > Config".
Table 5-5: DCI formats overview [TS 38.212]
DCI format Usage
0_0 Scheduling of PUSCH in one UL cell
See "DCI Format 0_0" on page 109.
0_1
See "DCI Format 0_1" on page 110.
1_0 Scheduling of PDSCH in one DL cell (allocation type 1)
See "DCI Format 1_0" on page 112.
1_1 Scheduling of PDSCH in one DL cell
See "DCI Format 1_1" on page 113.
2_0 Notifying a group of UEs of the slot format
2_1 Notifying a group of UEs of the PRBs and OFDM symbols where UE can
assume that no transmission is intended for the UE
2_2 Transmission of TPC commands for PUCCH and PUSCH
2_3 Transmission of a group of TPC commands for SRS transmissions by one or
more UEs
Remote command:
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:CS:DCI<s2us0>:FMT on page 238
Search Space ← DCI Table
Defines the search space for the selected DCI.
The search space defines the set of PDCCH candidates that a UE has to monitor.
Search spaces can be common search space (CSS) and UE-specific search space
(USS), where the non-common DCIs are mapped to the USS. The UE can decode only
the control information that is transmitted within one or more search spaces this UE
monitors.
TS 38.213 defines the search spaces listed in "Search Space" on page 107.
CORESET Settings