Rohde & Schwarz SMW-K144 - Page 238

Remote-Control Commands
R&S
®
SMW-K144
238User Manual 1178.8013.02 ─ 06
Parameters:
<RNTI> integer
Range: 0 to 65535
*RST: 0
Manual operation: See "RNTI" on page 106
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:CS:DCI<s2us0>:FMT <AllocDciFmt>
Sets the DCI format.
Parameters:
<AllocDciFmt> F00 | F01 | F10 | F11 | F20 | F21 | F22 | F23 | CUSTom
F20|F21|F22|F23 are reserved for future use.
*RST: F00
Example: See Example "Configuring the CORESET settings"
on page 157.
Manual operation: See "DCI Format" on page 107
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:CS:DCI<s2us0>:SSP <SearchSpace>
Sets the search space for the selected DCI.
Parameters:
<SearchSpace> USS | CSS0 | CSS1 | CSS2 | CSS3
*RST: USS
Example: See Example "Configuring the CORESET settings"
on page 157.
Manual operation: See "Search Space" on page 107
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:CS:DCI<s2us0>:AGGLevel <DciAggLvl>
Sets the aggregation level for the selected DCI.
Parameters:
<DciAggLvl> AL1 | AL2 | AL4 | AL8 | AL16
*RST: 4
Example: See Example "Search space configuration" on page 156.
Manual operation: See "Aggregation Level" on page 108
CORESET Commands