Rohde & Schwarz SMW-K144 - Page 239

Remote-Control Commands
R&S
®
SMW-K144
239User Manual 1178.8013.02 ─ 06
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:CS:DCI<s2us0>:CANDidate <Candidate>
Selects the candidate number for the selected aggregation level, where the maximum
number of candidates per aggregation level are set with the command [:
SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:CS:DMRS:SPACe<s2us0>:MAXCandidate.
Parameters:
<Candidate> integer
Range: 0 to 8
*RST: 0
Example: See Example "Search space configuration" on page 156.
Manual operation: See "Candidate" on page 108
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:CS:DCI<s2us0>:INDex <DciCCEIdx>
If [:SOURce<hw>]:BB:NR5G:SCHeduling:RSSPace 0, sets the index and thus the
position of the first CCE of the PDCCH.
Parameters:
<DciCCEIdx> integer
Range: 0 to 10
*RST: 0
Example: See Example "Search space configuration" on page 156.
Manual operation: See "CCE Index" on page 108
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:CS:DCI<s2us0>:CPDSch <CreatePDSCH>
Use this command to create the content and scheduling of the PDSCH automatically,
as configured with the DCI format 1_0 parameters.
Parameters:
<CreatePDSCH> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Configuring the CORESET settings"
on page 157.
Manual operation: See "Create PDSCH" on page 109
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:CS:DCI<s2us0>:HBTS?
Queries the resulting bit data as selected with the DCI format parameters.
CORESET Commands