Rohde & Schwarz SMW-K144 - Page 237

Remote-Control Commands
R&S
®
SMW-K144
237User Manual 1178.8013.02 ─ 06
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:CS:DCCes:PATTern <Pattern>, <BitCount>
Sets a bit pattern as a data source.
Parameters:
<Pattern> numeric
*RST: #H0
<BitCount> integer
Range: 1 to 64
*RST: 1
Example: See Example "Configuring the CORESET settings"
on page 157.
Manual operation: See "Dummy CCEs Data Source" on page 105
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:CS:NDCI <NumDci>
Sets the number of DCIs.
Parameters:
<NumDci> integer
Range: 1 to 4
*RST: 1
Example: See Example "Configuring the CORESET settings"
on page 157.
Manual operation: See "Number of DCIs" on page 106
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:CS:DCI<s2us0>:USAGe <Usage>
Queries the RNTI with that the CRC is scrambled.
Parameters:
<Usage> C | CS | P | SI | RA | TC | SPCS | SFI | INT | TPUS | TPUC |
TSRS
*RST: C
Example: See Example "Configuring the CORESET settings"
on page 157.
Manual operation: See "Usage" on page 106
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:CS:DCI<s2us0>:RNTI <RNTI>
Queries the C-RNTI of the associated user.
CORESET Commands