Rohde & Schwarz SMW-K144 - Page 236

Remote-Control Commands
R&S
®
SMW-K144
236User Manual 1178.8013.02 ─ 06
Parameters:
<MaxCandidate> 1 | 2 | 3 | 4 | 5 | 6 | 8
*RST: 1
Example: See Example "Configuring the CORESET settings"
on page 157.
Manual operation: See "Max Candidates" on page 104
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:CS:DCCes:STATe <DummyCceState>
If enabled, the CCEs are filled in with dummy data.
Parameters:
<DummyCceState> 0 | 1 | OFF | ON
*RST: 1
Example: See Example "Configuring the CORESET settings"
on page 157.
Manual operation: See "Dummy CCEs" on page 105
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:CS:DCCes:DATA <DummyCceDataSrc>
Sets the data source for the dummy CCEs.
Parameters:
<DummyCceDataSrc>PN9 | PN11 | PN15 | PN16 | PN20 | PN21 | PN23 | PATTern |
DLISt | ZERO | ONE
*RST: PN9
Example: See Example "Configuring the CORESET settings"
on page 157.
Manual operation: See "Dummy CCEs Data Source" on page 105
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:CS:DCCes:DLISt <DummyCceDataLst>
Selects an existing data list file from the default directory or from the specific directory.
Parameters:
<DummyCceDataLst>string
Filename incl. file extension or complete file path
Example: See Example "Configuring the CORESET settings"
on page 157.
Manual operation: See "Dummy CCEs Data Source" on page 105
CORESET Commands