Rohde & Schwarz SMW-K144 - Page 167

Remote-Control Commands
R&S
®
SMW-K144
167User Manual 1178.8013.02 ─ 06
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:CBW.........................................................168
[:SOURce<hw>]:BB:NR5G:NODE:RFPHase:STATe.......................................................... 168
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:PCFReq.................................................... 168
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:TAPos....................................................... 169
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:SUL:STATe................................................ 169
[:SOURce<hw>]:BB:NR5G:NODE:NCARrier <NumCarrier>
Sets the number of simulated carriers.
Parameters:
<NumCarrier> integer
Range: 1 to 16
*RST: 1
Example: See Example "Configuring the carrier" on page 148.
Manual operation: See "Number of Carriers" on page 30
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:CELLid
<CellId>
Sets the cell identity of the selected cell.
Parameters:
<CellId> integer
Range: 0 to 1007
*RST: 0
Example: See Example "Configuring the carrier" on page 148.
Manual operation: See "Cell ID" on page 31
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:CINDicator <CellIndicator>
Sets the cell indicator.
Parameters:
<CellIndicator> integer
Range: 0 to 15
Example: See Example "Configuring the carrier" on page 148.
Manual operation: See "Cell Indicator" on page 31
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:N1ID?
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:N2ID?
Queries the physical cell indicator group (N
ID
(1)
) and the physical layer identity (N
ID
(2)
).
Return values:
<CarrierN2Id> integer
Range: 0 to 2
*RST: 0
Carrier Commands