Rohde & Schwarz SMW-K144 - Page 198

Remote-Control Commands
R&S
®
SMW-K144
198User Manual 1178.8013.02 ─ 06
Manual operation: See "Row" on page 67
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:CSIRs:
ZP:SET<gr0>:RES<user0>:PORTs?
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:CSIRs:
NZP:SET<gr0>:RES<user0>:PORTs?
Sets the number of ports X.
Return values:
<Ports> 1 | 2 | 4 | 8 | 12 | 16 | 24 | 32
*RST: 1
Example: See Example "Configuring the CSI-RS settings" on page 155.
Usage: Query only
Manual operation: See "Ports" on page 67
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:CSIRs:
ZP:SET<gr0>:RES<user0>:DENSity <Density>
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:CSIRs:
NZP:SET<gr0>:RES<user0>:DENSity <Density>
Sets the parameter density.
Parameters:
<Density> EVE5 | ODD5 | DEN1 | DEN3
*RST: DEN3
Example: See Example "Configuring the CSI-RS settings" on page 155.
Manual operation: See "Density" on page 67
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:CSIRs:
ZP:SET<gr0>:RES<user0>:CDMType?
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:CSIRs:
NZP:SET<gr0>:RES<user0>:CDMType?
Queries the higher-level parameter cdm-Type.
The value is automatically, depending on the value set with the command [:
SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:CSIRs:
NZP:SET<gr0>:RES<user0>:ROW on page 197
Return values:
<CDMType> NOCDm | CDM2 | CDM4 | CDM8
*RST: NOCDm
Example: See Example "Configuring the CSI-RS settings" on page 155.
Usage: Query only
Manual operation: See "CDM-Type" on page 67
BWP Configuration Commands