EasyManua.ls Logo

Rohde & Schwarz SMW-K144 - Page 67

Rohde & Schwarz SMW-K144
285 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5G New Radio Configuration and Settings
R&S
®
SMW-K144
67User Manual 1178.8013.02 ─ 06
Periodic NZP CSI-RS resource table
Each periodic NZP CSI-RS is configured individually; there is one table row per
resource, where the number of rows is defined by the parameter Resources.
Periodicity ← Periodic NZP CSI-RS resource table
Sets the periodicity T
CSI-RS
(in slots) transmitted by the higher-layer parameter
CSI-ResourcePeriodicityAndOffset.
Thus, this parameter defines how often the CSI-RS is transmitted.
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
CSIRs:NZP:SET<gr0>:RES<user0>:PER on page 197
Offset ← Periodic NZP CSI-RS resource table
Sets the slot offset T
offset
transmitted by the higher-layer parameter
CSI-ResourcePeriodicityAndOffset.
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
CSIRs:NZP:SET<gr0>:RES<user0>:OFFSet on page 197
Row ← Periodic NZP CSI-RS resource table
The CSI-RS location in a slot is defined according to TS 38.211 as a function of the
number of ports X (Ports), the Density and the CDM-Type.
The possible combinations are listen in a table and the parameter "Row" indicates one
of the combinations. It is not the consequent table row number in the CSI-RS resource
table. The latter is defined with the suffix RES<user0> in the remote control command.
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
CSIRs:NZP:SET<gr0>:RES<user0>:ROW on page 197
Ports ← Periodic NZP CSI-RS resource table
Sets the number of ports X that is given by the higher-layer parameter nrofPorts.
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
CSIRs:NZP:SET<gr0>:RES<user0>:PORTs? on page 198
Density ← Periodic NZP CSI-RS resource table
Sets the value ρ that is the higher-layer parameter density in the
CSI-RS-ResourceMapping or the CSI-RS-CellMobility messages.
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
CSIRs:NZP:SET<gr0>:RES<user0>:DENSity on page 198
CDM-Type ← Periodic NZP CSI-RS resource table
Indicates or sets value of the higher-layer parameter cdm-Type in the
CSI-RS-ResourceMapping.
Users/BWPs Settings

Table of Contents

Related product manuals