Rohde & Schwarz SMW-K144 - Page 68

5G New Radio Configuration and Settings
R&S
®
SMW-K144
68User Manual 1178.8013.02 ─ 06
The value is selected automatically according to TS 38.211 and depending on the
selected Row.
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
CSIRs:NZP:SET<gr0>:RES<user0>:CDMType? on page 198
Bitmap ← Periodic NZP CSI-RS resource table
Sets the location of the NZP CSI-RS in the frequency domain, where the starting posi-
tion and number of the resource blocks in which the CSI-RS is transmitted are defined
by the higher-layer parameters freqBand.
This parameter is transmitted by the higher-layer parameters
frequencyDomainAllocation as part of the CSI-RS-ResourceMapping or the
CSI-RS-CellMobility messages.
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
CSIRs:NZP:SET<gr0>:RES<user0>:BITMap on page 199
l0/l1 ← Periodic NZP CSI-RS resource table
Sets the parameters l
0
and l
1
and define the ZP CSI-RS location relative to the start of
as slot. Thus, the l
0
and l
1
give the location of the CSI-RS in time.
Thess parameters are transmitted by the higher-layer parameters
firstOFDMSymbolInTimeDomain and firstOFDMSymbolInTimeDomain2 as
part of the CSI-RS-ResourceMapping or the CSI-RS-CellMobility messages.
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
CSIRs:NZP:SET<gr0>:RES<user0>:I0 on page 199
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
CSIRs:NZP:SET<gr0>:RES<user0>:I1 on page 199
Scrambling ID ← Periodic NZP CSI-RS resource table
Sets the parameter n
ID
that is defined by the higher-layer parameter ScramblingID
and used for the generation of the pseudo-random reference-signal generator.
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
CSIRs:NZP:SET<gr0>:RES<user0>:SCID on page 199
Power ← Periodic NZP CSI-RS resource table
Sets the power of the NZP ressource relative to the PDSCH power.
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
CSIRs:NZP:SET<gr0>:RES<user0>:PWR on page 200
Antenna Ports ← Periodic NZP CSI-RS resource table
Opens the "Resource-APs" dialog where you configure the antenna port mapping for
the selected resource, see Resource-APs > Antenna Port Mapping.
Users/BWPs Settings