Fader Bank Section
121
Anchor Channels
You can mark channels you want to access rapidly in the various
layers. These are called “anchor channels.”
Specifying anchor channels in the respective layers lets you quickly
jump to the desired channel. You can register up to 8 anchor
channels in each layer.
You can select anchor channels in the function mode.
0“Setting an Anchor Channel” (p. 126)
Memo
In the default settings, preset anchors are present in the
CHANNEL layer at every 24th channel and in the DCA/BUS layer
by channel type (DCA, MAIN, SUBGROUP, and the like).
Accessing an Anchor Channel (Anchor Jump)
1. Press [SCROLL K] and [SCROLL J] at the same time.
Anchor channels registered in the currently selected layer are
shown on the fader display.
2. Press the [SEL] button that corresponds to the desired
anchor channel.
The fader bank scrolls to the location where the anchor channel is
displayed in the leftmost fader.
Accessing Adjacent Anchor Channels
Pressing and holding the [SCROLL K] or [SCROLL J] button scrolls
forward or backward to the anchor channel nearest the currently
accessed channel.
An orange bar is displayed in the fader bank display to the right of
the anchor/jumped fader bank. For each respective layer, this shows
the approximate position of the channel loaded into the fader bank.
To Next Page
Loading...
