Roland M-5000 - Display Section Details

Part Names and Functions
31
Assignable Fader Section
This section lets you assign any four channels of you choosing to the 4 assignable faders. This makes it possible to keep important channels accessible
at all times.
For details, refer to the "Assignable Fader Section" in the Reference Manual (PDF).
Fader Bank display
[SEL] button
[SOLO] button
Level meter
[MUTE] button
Fader
Name Description
Fader Bank display
This displays information such as the input channel/output bus name and fader value. In the Function mode, it displays
information such as a list of functions and parameter values.
[SEL] button
This selects the input channel/output bus and selects the display target. In the function mode, it selects the function
and manipulates parameters.
[SOLO] button This turns solo on and o for the input channel/output bus.
Level meter This displays the signal level of the input channel/output bus.
[MUTE] button This turns muting on and o for the input channel/output bus.
Fader This operates the fader for the input channel/output bus.
USB MEMORY Connector
The M-5000 can use a USB ash drive to store and load a variety of data.
5 Project les
0“Saving a Project File to a USB Flash Drive” (p. 61)
0“Loading a Project File from a USB Flash Drive” (p. 62)
5 Recording and playback of WAV les using a USB ash drive
0“Recording/Playback to/from a USB Flash Drive” (p. 60)
NOTE
* Never turn o the power or disconnect a USB ash drive when the access light of the device is lit or blinking
* Carefully insert the USB ash drive all the way in—until it is rmly in place.
* Some USB ash drive types or USB ash drives from some manufacturers may not record or play back properly.
* All USB ash drives eventually wear out. We recommend that you consider the USB ash drive not as a permanent storage site, but as a place to
store data temporarily. We also recommend that you back up important data onto another media.
Memo
5 Before using a USB ash drive on this unit, please format the USB ash drives using the built-in format function.
0“Formatting a USB Flash Drive on the M-5000” (p. 63)
5 Some USB ash drives might not be able to be used on this unit. If an error message appears when formatting as described in “Formatting a USB
Flash Drive on the M-5000” (p. 63), it is not possible to use this USB ash drive on the M-5000.
5 The M-5000 supports only USB ash drives (USB ash Memory and USB memory). USB Hard Disk and Memory Card Readers are not supported.
5 USB ash drives do not work via USB hub.