Roland M-5000 - Recalling a Scene; Storing a Scene (by Overwriting)

Scene Memory
178
Memo
Newly created or added scenes are each automatically given
a scene number (having up to two digits to the right of the
decimal point).
If no next scene exists, the scene is created and given a scene
number equal to the number of the selected scene plus one.
If the next scene exists, the scene is created and given an
intermediate scene number.
Storing a Scene (by Overwriting)
1. Go to the scene section on the top panel and press the
[SELECT H] or [SELECT I] button to select the number of
the scene you want to store.
2. Press the [STORE] button.
A popup prompting you to conrm the operation is displayed.
M-48 MEMORY
CANCEL This cancels the operation and exits the popup.
M-48 MEMORY This selects the M-48 memory.
M-48 MEMORY
STORE
When this is on, saving a scene by overwriting
saves all M-48 mixer settings to the memory
number selected using <M-48 MEMORY>.
3. Press the [STORE] button.
The scene is stored.
Recalling a Scene
1. Go to the scene section on the top panel and press the
[SELECT H] or [SELECT I] button to select the number of
the scene you want to recall.
2. Press the [RECALL] button.
A popup prompting you to conrm the operation is displayed.
CANCEL This cancels the operation and exits the popup.