Roland M-5000 - Interlinking with M-48 Memory; Setting a GPO Connector

Scene Memory
186
Setting a GPO Connector
This species the GPO connector to output a signal on recall.
1. Tap <EVENTS> for the scene you want to assign to the
connector.
The EVENTS window appears.
MIDI This displays the MIDI window.
GPI/O / FS This displays the GPI/O / FOOT SW window.
CLEAR This clears the assigned function.
CANCEL This cancels the change and closes the window.
2. Tap <PIN>.
This displays a popover for selecting the GPO connector.
3. Select the GPO connector.
4. Tap <OUTPUT>.
A popover for selecting the output waveform appears.
5. Select the output waveform.
6. Tap <APPLY>.
This makes output of the specied waveform occur on scene recall.
Interlinking with M-48 Memory
When an M-5000 scene memory is recalled, you can simultaneously
also recall an M-48 memory.
1. Tap <M-48> for the desired scene.
A popover for selecting the M-48 memory number appears.
2. Select the M-48 memory number.
When the scene you selected in step 1 is recalled, this M-48
memory is simultaneously recalled.