Roland M-5000 - Selecting the Source for an Input Channel; Selecting the Destination for an Output Bus

Overview of Operations
51
Selecting the Source for an Input Channel
1. Access the CH EDIT window for the desired input channel.
0“Access the CH EDIT window” (p. 50)
2. Tap the <INPUT tab>.
INPUT tab
IN
3. Tap <IN>.
The SOURCE popover appears.
4. Tap <CATEGORY> and select the source type.
5. Select the desired source.
Selecting the Destination for an Output
Bus
1. Access the CH EDIT window for the desired output bus.
0“Access the CH EDIT window” (p. 50)
2. Tap the <OUTPUT tab>.
OUTPUT tab
OUT
3. Tap <OUT>.
The DESTINATION popover appears.
4. Tap <CATEGORY> and select the output-destination type.
5. Select the desired output destination.