Roland M-5000 - Formatting a USB Flash Drive on the M-5000; Muting All Outputs; Setting the Date and Time; Factory Reset

Overview of Operations
63
Formatting a USB Flash Drive on the
M-5000
1. Press the [MENU] button.
2. On the MENU window, tap <SETUP>, then tap
<PROJECT>.
The PROJECT window appears.
3. Tap <FORMAT>.
A popup prompting you to conrm the operation is displayed.
4. Tap <FORMAT>.
Formatting of the USB ash drive starts.
Muting All Outputs
This mutes all outputs at times such as when turning the M-5000’s
power on or o.
1. Press the [MENU] button.
2. On the MENU window, tap <MUTE GROUP>.
The MUTE GROUP MASTER window appears.
3. Turn on <MUTE ALL OUTPUTS>.
This mutes all outputs on the M-5000 and input/output units.
Setting the Date and Time
1. On the HOME screen, tap <DATE & TIME AREA>.
The DATE & TIME window appears.
2. Set the date and time, then tap <SET>.
The settings for the date and time are applied.
Factory Reset
This initializes the M-5000, returning it to its factory-default state.
NOTE
Performing initialization causes all data to be lost.
Data that is needed can be saved to a USB ash drive.
0“Backing Up All Data in the M-5000” (p. 61)
0“Restoring All Data in the M-5000” (p. 62)
1. Go to the Display section on the top panel, and while
holding down the [MENU] button and [VIEW] button, turn
on the power to the M-5000.
2. Tap <FACTORY INITIALIZE>.
A popup prompting you to conrm the initialization operation is
displayed.
3. Tap <INITIALIZE>.
Initialization starts.
NOTE
Never turn o the power to the M-5000 before initialization
nishes.
The factory reset will require approximately 10 minutes.
4. When “Factory Initialize completed.” appears, tap <OK>.
5. Turn o the power.