EasyManua.ls Logo

Roland M-5000 - Core Operational Components; Control and Connectivity Options; User Interface and Assignable Sections

Roland M-5000
276 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
13
Update History
Ver.1.101
Additional Functions
5 Monitor system functionality ( M-48 MANAGER ) that uses the
M-48 was added.
0“M-48 Control” (p. 199)
5 Remote control functionality that uses GPIO, footswitch pedals,
and MIDI was added.
0“GP I/O and Foot Switches (p. 250)
0“MIDI” (p. 248)
5 Support for the XI-MADI ( MADI EXPANSION INTERFACE ) was
added.
0“XI-MADI” (p. 247)
Functionality Improvements
5 Operation at the GEQ EDIT window was improved.
5 Operation feel when adjusting EQ FREQ, DYNAMICS ATTACK/
RELEASE, or the like in the knob section was enhanced.
5 <ALL CH SEND POINTS> was added to the MENU window.
0“MENU Window” (p. 195)
Bug Fixes
5 In rare cases, the M-5000 becomes unstable when performing
the following operations.
5 Scene NEW, STORE, DUPLICATE, LOCK, SKIP, or RECALL PARAMETER
change
5 Eect library STORE or LOCK
5 Loading a project le
5 In rare cases, the Gain, Pad, and Phantom values for a REAC
device connected to an XI-REAC card dier from the values
displayed on the M-5000.
5 MTX INPUT settings are not replicated when recalling a scene
stored with MIXER CONFIGURATION in a dierent state.
5 Even when CROSS-MATRIX LCR has been enabled using MIXER
CONFIGURATION, it is disabled after the power is reset.
5 Noise occurs in the FX3 R-channel audio signal when SAMPLING
FREQ is set to 96 kHz.
Ver.1.020
Additional Functions
5 The XI-DANTE (DANTE EXPANSION INTERFACE) is supported.
0“XI-DANTE” (p. 246)
Functionality Improvements
5 When storing a scene by overwriting, the RECALL PARAMETER
setting persists.
Bug Fixes
5 Music from an iPad connected by a DOCK cable sometimes
failed to play.
Ver.1.001
Functionality Improvements
5 Skip/lock setting-change response at the "SCENE" screen was
improved.
5 Motor fader operation was improved.
Bug Fixes
5 Performing successive scene store operations sometimes results
in a system lockup.
5 When creating/adding a scene, the correct scene number
sometimes failed to be assigned.
5 Selecting "LIBRARY" at SECTIONS in the INITIALIZE window
failed to initialize the eect library.
5 Anchor channel settings after a factory reset dier from the
description in the owner's manual.
5 Solo in Place sometimes fails to operate correctly.
5 Minor problems when an expansion interface (XI-REAC, etc.) is
installed.

Table of Contents

Other manuals for Roland M-5000

Related product manuals