REAC Applications and EXPANSION SLOT Settings
247
XI-MADI
The setting items shown below are displayed when an XI-MADI is
installed in the expansion slot.
STATUS
STATUS
STATUS
Displays the link status of the MADI IN 1/2
connector.
5 LINKED: Linked normally
5 LINKING: Establishing a connection, or
the unit’s sampling rate diers from the
input signal.
5 UNLINKED: No MADI device is
connected, or no connection can be
established.
CH MODE
Sets the maximum number of MADI
channels to output.
You set this to correspond to the mode
setting of connected MADI equipment.
5 64
5 56
INPUT
Selects the input connector.
5 OPTICAL
5 COAXIAL
5 AUTO: Automatically selects OPTICAL
or COAXIAL (with COAXIAL taking
precedence). The same input connector
remains selected until the input signal
ends.
BACKUP MODE
When set to ON, the MADI IN/OUT
connectors 2 function as a backup of the
MADI IN/OUT connectors 1.
When set to OFF, the MADI IN/
OUT connectors 1 and 2 operate
independently.
VIDEO IN
Displays the status of the VIDEO SYNC IN
connector.
5 OK
5 NO SIGNAL
VERSION XI-MADI version information
* When making the XI-MADI a clock source, go to the WORD
CLOCK window and set the expansion slot where the XI-MADI is
installed to be the clock source.
* The MADI IN 1 connector and VIDEO SYNC IN connector can be
set to a clock source.
To Next Page
Loading...
Need help?
General
