The ConfigManager's layout is similar to that of ScanManager. Similar to ScanManager the
configuration options provided in ConfigManager are divided into different functions by topics:
Status: Different status information on the scanner is displayed (see 6.3).
Calibration: Here, you can calibrate the scanner again (see 6.4).
Printer: Management of printers which can be used in ScanManager (see 6.5)
Licenses: Display of existing license options, loading of license upgrades (see 6.6).
Update: Here you can check whether a new version of the ROWE Scan 600 software is
available (see 6.7).
Parameter: Administration of general parameters (see 6.8).
Login: Authentication / access protection for advanced settings (see 6.9).
Favorites: Here you can set additional options for the behavior of the favorites in
ScanManager (see 6.10).
In some sections of ConfigManager you are guided through the setup of the
selected options by wizards. At the bottom edge of ConfigManager the two
buttons "Next" and "Back" are displayed then. In order to reach the next step,
simply actuate "Next". By means of "Back" you can return to the previous step
to correct your selection if applicable.
To Next Page
Loading...
