Installing the Access Point
Step 1: Preconfigure the Access Point
ZoneFlex Indoor Access Point 9.8.1 User Guide, 800-70601-001 Rev C 89
2 Verify that the common wireless settings are configured as listed in Tab l e 44.
3 If you made any changes to the Common tab, click Update Settings.
4 Continue to “Configure Wireless # Settings” below.
Configure Wireless # Settings
1 Click one of the Wireless # tabs.
Table 44. Common wireless configuration
Setting Recommended Value
Wireless Mode For ZoneFlex 7321, select 2.4GHz or 5GHz mode.
For other APs, the wireless mode is determined by the radio band
(Wireless 2.4G or Wireless 5G).
Channel SmartSelect.
Country Code • If you purchased the Access Point in the United States, this value
is fixed to
United States at the factory and is not user
configurable.
• If you purchased the Access Point outside the United States, verify
that the value is set to your country or region. Selecting the correct
country code ensures that the Access Point uses only the radio
channels allowed in your country or region.
Note for dual band AP users: The two radios on dual band APs are
always configured with the same country code setting. If you change
the country code for Radio 1, for example, the same change is
automatically applied to Radio 2.
To Next Page
Loading...
