Configuration Guide Configuring WIDS
mac-address H.H.H: Configures the unknown STA list entry, empty by default.
mac-address max num: Configures the unknown STA list length, ranging from 1 to 256.
Unknown STA detection and containment is disabled.
The containment function has no effect when the AP operates in Normal mode.
Configuring the Maximum Number of Detected APs
Optional. Run the device detected-ap-max num command to configure the maximum number of detected APs in
WIDS configuration mode. A smaller configuration value leads to less data being detected on the AP. If less data is
detected, the device containment function may not show an obvious containment effect. A larger configuration value
requires more memory.
Unless otherwise noted, configure this on ACs which need the maximum number of detected APs.
device detected-ap-max num
num: Indicates the maximum number of detected APs, ranging from 1 to 4,096.
The default maximum number is 2,048.
Configuring the Scanning Status of a Specified Radio
Optional. Run the hybrid-scan radio num { disable | enable } command to configure the scanning status of a specified
radio in WIDS configuration mode. If disabling the configuration leads to AP working in non-normal mode, there will be
no device detection data.
hybrid-scan radio num { enable | disable }
num: Indicates a radio ID.
All radio scanning is enabled by default.
Configuring the Scanning Channel of a Specified AP
Optional. Run the scan-channels { 802.11a | 802.11b } channels num1 num2…num13 command to configure the
scanning channel in WIDS configuration mode. If the scanning channel is not configured, there will be no device
detection data when the AP operates not in Normal mode.
scan-channels { 802.11a | 802.11b } channels num1 num2…num13
num: Indicates a channel number.
To Next Page
Loading...
