Ruijie RG-WLAN Series - Page 103

Configuration Guide Configuring WIDS
Description
Defaults
The scanning channel is null.
Command
Mode
WIDS configuration mode
Usage Guide
N/A
Verification
 Run the show wids detected command to display the detected results.
Configuration Example
N/A
2.4.5 Configuring AP Working Mode
Configuration Effect
 Based on the configured working mode, the AP can provide different services.
Notes
N/A
Configuration Steps
 Configuring AP Working Modes
 Optional.
 Unless otherwise noted, configure this on each AP.
Command
device mode { hybrid | monitor | normal }
Parameter
Description
hybrid: Indicates Hybrid mode, in which the device provides both monitoring service and access service.
monitor: Indicates Monitor mode, in which the device provides only the monitoring service.
normal: Indicates Normal mode, in which the device provides only the access service.
Defaults
The working mode of the AP is Normal.
Command
Mode
WIDS configuration mode
Usage Guide
N/A
Verification
 Run the show ap-config running ap-name command to display the current working mode of the AP.
Configuration Example
N/A