Configuration Guide Configuring Syslog
By default, the syslog uses the datetime timestamp format, and the timestamp does not contain the year and millisecond.
Run the service timestamps command in global configuration mode to use the datetime timestamp format that contains the
year and millisecond in the syslog, or change the datetime format to the uptime format.
 Adding Sysname to the Syslog
By default, the syslog does not contain sysname.
Run the service sysname command in global configuration mode to add sysname to the syslog.
 Adding the Sequence Number to the Syslog
By default, the syslog does not contain the sequence number.
Run the service sequence-numbers command in global configuration mode to add the sequence number to the syslog.
 Enabling the Standard Log Format
By default, logs are displayed in the following format:
*timestamp: %module-level-mnemonic: content
Run the service standard-syslog command in global configuration mode to enable the standard log format and logs are
displayed in the following format:
timestamp %module-level-mnemonic: content
Compared with the default log format, an asterisk (*) is missing in front of the timestamp, and a colon (:) is missing at the end
of the timestamp in the standard log format.
 Enabling the Private Log Format
By default, logs are displayed in the following format:
*timestamp: %module-level-mnemonic: content
Run the service private-syslog command in global configuration mode to enable the private log format and logs are
displayed in the following format:
timestamp module-level-mnemonic: content
Compared with the default log format, an asterisk (*) is missing in front of the timestamp, a colon (:) is missing at the end of
the timestamp, and a percent sign (%) is missing at the end of the module name in the private log format.
7.3.3 Logging Direction
Configure parameters for sending syslogs in different directions, including the Console, monitor terminal, buffer, the log
server, and log files.
Related Configuration
 Configuring the Log Rate Limit
By default, no log rate limit is configured.
To Next Page
Loading...
Need help?
General
