Configuration Guide Configuring RLOG
port 20000 server 192.168.1.100
port 20000 server 10.10.10.1
rlog dev-ip 0.0.0.0
rlog export-rate 10000 rlog queue remain 10000
send log count : 0 error count : 0 errorno : 0
recv buf: 0 poll buf err: 0 push buf: 0 local buf: 0
recv err cnt: 0 depatch err cnt: 0
enable log combination: 0
If export succeeds, the value of send log count will rise.
Common Errors
Though the RLOG server is configured, the RLOG type is not specified.
Though the RLOG server and type are configured, the log module is not enabled.
8.4.2 Configuring RLOG Parameters
Configuration Effect
RLOG operates with a better performance.
Notes
In case of RLOG malfunction, make sure to fully understand each command parameter before the configuration.
Configuration Steps
Optional
Verification
Check whether RLOG export normally and the servers receive the logs.
Related Commands
Setting the RLOG export rate
val: RLOG export rate (the export maximum per second)
Global configuration mode
The RLOG export rate is determined by device and server performance as well as log outputs. Too low
To Next Page
Loading...
Need help?
General
