Ruijie RG-WLAN Series - Page 14

Configuration Guide Configuring STA Management
AP1(config-czone)# exit
AP1(config)#assoc-control
AP3
AP3#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
AP3 (config)# package Cart 1
AP3(config-package)#primary-sta 00d0.f800.0001
AP3(config-package)#secondary-sta 00d0.f800.0002
AP3(config-package)#secondary-sta 00d0.f800.0003
AP3(config-package)# exit
AP3(config)# control-zone Classroom 2
AP3(config-czone)# apAP3
AP3(config-czone)# exit
AP3(config)#assoc-control
Verification
 Display the association control running state.
 Display the package configuration.
 Display the association control zone configurations.
AP1
AP1#show assoc-control
Association control is enabled.
AP1# show package
total package num : 1
========= Cart 1 =========
primary STA : 00d0.f800.0001
secondary STA num : 2
00d0.f800.0002
00d0.f800.0003
AP1# show control-zone
control zone num : 1
control-zoneAP
------------- ------------------------
Classroom 1 AP1 00d0.f800.889e
AP3
AP3#show assoc-control