Ruijie RG-WLAN Series - Page 17

Configuration Guide Configuring Ethernet Management
3.3.2 LAN port Bandwidth Restriction
3.3.2.1 Working Principle
The LAN port bandwidth restriction function is used to configure the maximum bandwidth of various LAN ports of APs so as
to avoid the slow Internet access of wireless users caused in a scenario where wireless and wired users coexist and wired
users occupy a substantial bandwidth.
3.4 Configuration
Configuration
Description and Command
Configuring the Maximum
Bandwidth of LAN ports
(Optional) It is used to configure the maximum bandwidth of LAN ports of APs.
wired-rate value
Configures the maximum bandwidth (in
Mbps) of various LAN ports of the AP.
3.4.1 LAN port Bandwidth Restriction
3.4.1.1 Networking Requirements
 Configure the maximum bandwidth of various LAN ports.
3.4.1.2 Notes
The wired-rate
value
command is supported only on AP120-W and AP130-W.
Model
Maximum Speed
AP120-W
100Mbps
AP130-W
100Mbps
3.4.1.3 Configuration Steps
Configuring the LAN Port Bandwidth Restriction Function
 The configuration is optional.
 Perform this configuration on a fat AP.