Configuration Guide Configuring WQoS
Configuring the Fair Scheduling Priority
(Optional) Perform this configuration if you need to change the fair scheduling priority of a STA.
On a fat AP, run the sta-fair command in global configuration mode to configure the fair scheduling priority.
sta-fair mac-address priority priority
mac-address: Indicates the MAC address of a STA.
priority: Indicates the priority. The value ranges from 1 to 6.
By default, the priority is 1 for all STAs. A greater value indicates a higher priority, and a higher priority
indicates that a longer time is allocated to the STA.
Global configuration mode
Verification
Run the show ap-config run command to display the configurations.
Configuration Example
N/A
1.5 Monitoring
N/A
To Next Page
Loading...
Need help?
General
