Ruijie RG-WLAN Series User Manual

Configuration Guide Configuring FAT APs
 For a FAT-AP to forward data normally, you must configure the VLAN attributes encapsulated by the dot11radio
subinterface. Otherwise, STAs may not communicate normally even though they can access the VLAN. Run the
encapsulation dot1Q command to configure the VLAN attributes of the specified dot11radio subinterface.
 If there are no special requirementsIf there are no special requirements, you can perform this configuration in the
dot11radio subinterface configuration mode of the AP equipment.
Command
encapsulation dot1Q vlan-id
Parameter
Description
vlan-id: specifies a VLAN ID or VLAN GROUP ID.
Defaults
-
Command
Mode
dot11radio subinterface configuration mode
Usage Guide
-
 Configuring the WLAN ID Mapped to a dot11radio Subinterface
 For a FAT-AP to provide WLAN service, you must configure the WLAN ID that is mapped to a dot11radio interface. Run
the broadcast-ssid command to configure whether to broadcast an SSID.
 If there are no special requirementsIf there are no special requirements, you can perform this configuration in the
dot11radio sub-interfacesubinterface configuration mode of the AP equipment.
Command
wlan-id wlan-id
Parameter
Description
wlan-id: specifies a WLAN ID.
Defaults
-
Command
Mode
dot11radio subinterface configuration mode
Usage Guide
-
Verification
 Run the show running-config command to verify the configurations of a WLAN.
Configuration Example
 Configuring a dot11radio Subinterface

Ruijie RG-WLAN Series Specifications

General

Brand	Ruijie
Model	RG-WLAN Series
Category	Wireless Access Point
Language	English