Ruijie RG-WLAN Series - Page 200

Configuration Guide Configuring FAT APs
 If there are no special requirementsIf there are no special requirements, you can perform this configuration in the
dot11radio interface configuration mode of the AP equipment.
 If 11g is supported, 11g STAs can be accessed; otherwise, 11g STAs cannot be accessed.
Command
11gsupport enable
no 11gsupport enable
Parameter
Description
no: indicates that 11g is not supported.
Defaults
11g STA access is supported.
Command
Mode
dot11radio interface configuration mode
Usage Guide
The configuration is effective only when the RF interfaces of an AP operate at the 2.4 GHz band.
 Configuring Whether to Support 11n
 Optional.
 If there are no special requirementsIf there are no special requirements, you can perform this configuration in the
dot11radio interface configuration mode of the AP equipment.
 If 11n is supported, 11n STAs can be accessed; otherwise, 11n STAs cannot be accessed.
Command
11nsupport enable
no 11nsupport enable
Parameter
Description
no: indicates that 11n is not supported.
Defaults
11n STA access is supported.
Command
Mode
dot11radio interface configuration mode
Usage Guide
-
 Configuring Whether to Support 11ac
 Optional.
 If there are no special requirementsIf there are no special requirements, you can perform this configuration in the
dot11radio interface configuration mode of the AP equipment.
 If 11ac is supported, 11ac STAs can be accessed; otherwise, 11ac STAs cannot be accessed.
Command
11acsupport enable
no 11acsupport enable
Parameter
Description
no: indicates that 11ac is not supported.
Defaults
When an RF interface provides the 11ac capability, 11ac STA access is supported by default.
Command
Mode
dot11radio interface configuration mode
Usage Guide
-