Ruijie RG-WLAN Series - Page 199

Configuration Guide Configuring FAT APs
Command
sta-limit client-num
Parameter
Description
client-num: indicates the STA quantity, ranging from 1 to 128.
Defaults
The STA quantity based on an RF interface is limited to 32.
Command
Mode
dot11radio interface configuration mode
Usage Guide
-
 Configuring Whether to Support 11a
 Optional.
 If there are no special requirementsIf there are no special requirements, you can perform this configuration in the
dot11radio interface configuration mode of the AP equipment.
 If 11a is supported, 11a STAs can be accessed; otherwise, 11a STAs cannot be accessed.
Command
11asupport enable
no 11asupport enable
Parameter
Description
no: indicates that 11a is not supported.
Defaults
11a STA access is supported.
Command
Mode
dot11radio interface configuration mode
Usage Guide
The configuration is effective only when the RF interfaces of an AP operate at the 5 GHz band.
 Configuring Whether to Support 11b
 Optional.
 If there are no special requirements, you can perform this configuration in the dot11radio interface configuration mode
of the AP equipment.
 If 11b is supported, 11b STAs can be accessed; otherwise, 11b STAs cannot be accessed.
Command
11bsupport enable
no 11bsupport enable
Parameter
Description
no: indicates that 11b is not supported.
Defaults
11b STA access is supported.
Command
Mode
dot11radio interface configuration mode
Usage Guide
The configuration is effective only when the RF interfaces of an AP operate at the 2.4 GHz band.
 Configuring Whether to Support 11g
 Optional.