EasyManuals Logo

Ruijie RG-WLAN Series User Manual

Ruijie RG-WLAN Series
1243 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #205 background imageLoading...
Page #205 background image
Configuration Guide Configuring FAT APs
The higher the channel bandwidth, the more channel bandwidth available to STAs, but the fewer the channels that can
be configured, and the higher the probability of interference between neighboring channels.
Command
chan-width { 20 | 40 | 80 }
Parameter
Description
20: sets the channel bandwidth to 20 MHz.
40: sets the channel bandwidth to 40 MHz.
80: sets the channel bandwidth to 80 MHz.
Defaults
The channel bandwidth is 20 MHz.
Command
Mode
dot11radio interface configuration mode
Usage Guide
-
Configuring Enabling/Disabling of Short Prevention Interval
Optional.
If there are no special requirementsIf there are no special requirements, you can perform this configuration in the
dot11radio interface configuration mode of the AP equipment.
After the short prevention interval is enabled, the prevention time is reduced from 0.8 us to 0.4 us, which helps increase
the network throughput.
Command
short-gi enable chan-width {20 | 40 | 80}
no short-gi enable chan-width {20 | 40 | 80}
Parameter
Description
no: disables the short prevention interval.
20: indicates enabling/disabling the short prevention interval at the channel bandwidth of 20 MHz.
40: indicates enabling/disabling the short prevention interval at the channel bandwidth of 40 MHz.
80: indicates enabling/disabling the short prevention interval at the channel bandwidth of 80 MHz.
Defaults
The short prevention interval is enabled at 20 MHz and 40 MHz and disabled at 80 MHz.
Command
Mode
dot11radio interface configuration mode
Usage Guide
-
Configuring the Radio Type a/b
Optional.
If there are no special requirementsIf there are no special requirements, you can perform this configuration in the
dot11radio interface configuration mode of the AP equipment.
An AP supports RF transmission at the 2.4 GHz and 5 GHz bands. The user can specify the operating band of an AP.
Command
radio-type { 802.11a | 802.11b }
Parameter
Description
802.11a: sets the radio type to 5 GHz.
802.11b: sets the radio type to 2.4GHz.
Defaults
A single-band AP (provides Radio 1) supports the 2.4 GHz band. For a dual-band AP, Radio 1 supports the
2.4 GHz band and Radio 2 supports the 5 GHz band.
Command
dot11radio interface configuration mode

Table of Contents

Other manuals for Ruijie RG-WLAN Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ruijie RG-WLAN Series and is the answer not in the manual?

Ruijie RG-WLAN Series Specifications

General IconGeneral
BrandRuijie
ModelRG-WLAN Series
CategoryWireless Access Point
LanguageEnglish

Related product manuals