Ruijie RG-WLAN Series User Manual

Configuration Guide Configuring FAT APs
Mode
Usage Guide
-
 Configuring the Country Code
 Optional.
 If there are no special requirements, you can perform this configuration in the dot11radio interface configuration mode
of the AP equipment.
 A country code is used to identify a country where radio frequencies reside. The bands, channels, and power vary with
country codes. Before configuring an AP, specify the country code supported by this AP. If the configured country code
changes, the corresponding bands, channels and power also change.
Command
country-code country-code
Parameter
Description
country-code: indicates a country code.
Defaults
The country code is CN, indicating China.
Command
Mode
dot11radio interface configuration mode
Usage Guide
-
 Configuring the Receive Mode of an Antenna
 Optional.
 If there are no special requirements, you can perform this configuration in the dot11radio interface configuration mode
of the AP equipment.
 An AP uses different quantities of antennas for data receiving. In this way, the AP can receive signals in the double
spatial stream mode or three spatial stream mode over 802.11n, thus improving the data transmission performance of
the AP.
Command
antenna receive chain-mask
Parameter
Description
chain-mask: indicates the antenna selection mask, ranging from 1 to 7.
Defaults
The quantity of antennas and the default antenna selection mask vary with product models.
Command
Mode
dot11radio interface configuration mode
Usage Guide
-
 Configuring the Transmit Mode of an Antenna
 Optional.
 If there are no special requirements, you can perform this configuration in the dot11radio interface configuration mode
of the AP equipment.

Ruijie RG-WLAN Series Specifications

General

Brand	Ruijie
Model	RG-WLAN Series
Category	Wireless Access Point
Language	English