After the user configures RF parameters, verify the dot11radio interface based on displayed dot11radio
interface configurations.
Run the show running-config command to check the configurations of the dot11radio interface.
Ruijie#show running-config
!
interface Dot11radio 1/0
ip proxy-arp
rate-set 11b mandatory 5 11
rate-set 11b disable 1 2
rate-set 11g mandatory 5 11
rate-set 11g support 6 9 12 18 24 36 48 54
rate-set 11g disable 1 2
rate-set 11a mandatory 6 12 24
rate-set 11a support 9 18 36 48 54
rate-set 11n mcs-support 15
rate-set 11n mcs-mandatory 3
station-role root-ap
beacon period 300
beacon dtim-period 3
slottime long
rts threshold 1000
sta-limit 12
sta-idle-timeout 900
chan-width 40
radio-type 802.11b
antenna receive 3
antenna transmit 3
external-antenna enable
coverage-area-control 12
response-rssi 20
assoc-rssi 15
country-code CNI
power local 50
channel 11
mcast-rate 24
coverage-rssi 10
peer-distance 3000
!
To Next Page
Loading...
