Ruijie RG-WLAN Series User Manual

Configuration Guide Configuring FAT APs
N/A
1.4.4 Configuring E-bag Parameters
Configuration Effect
 Configure the e-bag parameters of an AP and associated RF interfaces to facilitate configuration and management by
an administrator.
Notes
 N/A
Configuration Steps
 Configuring the Number of AMPDU Software Re-transmission Times
 (Optional) The default number of AMPDU software re-transmission times is 10.
 If there are no special requirement, you can perform this configuration in the dot11radio interface configuration mode of
the AP equipment.
 The larger the number of re-transmission times, the lower the probability of sub-frame loss. However, excessive
re-transmission times may cause increase of air interface load and decrease of real-time performance of other packets
in the air. In order to avoid packet loss when the probability of sub-frame loss is high, increase the value.
Command
ampdu-retries times
Parameter
Description
times: indicates the number of software re-transmission times, ranging from 1 to 100.
Command
Mode
dot11radio interface configuration mode
Usage Guide
The configuration is effective only when the RF interfaces of an AP operate at the 11n mode.
 Configuring Whether to Enable the RTS Protection for AMPDU Aggregation Packets
 (Optional) The RTS protection for AMPDU aggregation packets is disabled by default.
 If there are no special requirements, you can perform this configuration in the dot11radio interface configuration mode
of the AP equipment.
 The RTS protection for AMDPU needs to be enabled only when the waste of air interface resources caused by hidden
nodes is greater than that caused by RTS interaction.
Command
ampdu-rts
Parameter
Description
-
Command
Mode
dot11radio interface configuration mode
Usage Guide
The configuration is effective only when the RF interfaces of an AP operate at the 11n mode.

Ruijie RG-WLAN Series Specifications

General

Brand	Ruijie
Model	RG-WLAN Series
Category	Wireless Access Point
Language	English