Ruijie RG-WLAN Series - Page 22

Configuration Guide Configuring Data Plan
Command
data-planequeue-weightunicast-packet-weightmulticast-packet-weightbroadcast-packet-weightunknow
n-multicast-packet-weightunknown-unicast-packet-weight
Parameter
Description
unicast-packet-weight: sets the forwarding weight of unicast packets. The range is from 1 to 100
multicast-packet-weight: sets the forwarding weight of multicast packets. The range is from 1 to 50
broadcast-packet-weight: sets the forwarding weight of broadcast packets. The range is from 1 to 50
unknown-multicast-packet-weight: sets the forwarding weight of unknown multicast packets. The range is
from 1 to 25
unknown-unicast-packet-weight: sets the forwarding weight of unknown unicast packets. The range is
from 1 to 25
Defaults
Default weights are applied.
Command Mode
Global configuration mode
Configuration
Usage
N/A
4.4.1.4 Verification
 Run the show run command to display the configuration.
4.4.2 Configuring Broadcast Wireless Forwarding
4.4.2.1 Networking Requirements
 Useless broadcast packets are not forwarded to the air interface.
4.4.2.2 Notes
 N/A
4.4.2.3 Configuration Steps
Broadcast Forwarding Function
 Optional configuration. By default, the broadcast wireless forwarding function is disabled. Run the data-plane
wireless-broadcast command in global configuration mode to enable or disable this function.
Command
data-plane wireless-broadcast{ enable | disable }
Parameter
Description
enable: permits all broadcast packets to be forwarded to the air interface
disable: prohibits all broadcast packets from being forwarded to the air interface
Defaults
The broadcast wireless forwarding function is disabled; that is, broadcast packets are not forwarded to
the wireless network.
Command Mode
Global configuration mode
Configuration
Usage
N/A